Transportation of Rubber Hose

Hose in the loading and unloading process, should pay attention to the following points

Hose in the loading and unloading process, to do light loading and unloading.

The hose should be sorted into rolls (strips) and shipped neatly, to avoid excessive bending of the pipe body, and should not pile other heavy objects on the hose.

It is strictly prohibited to mix the hose with acid, alkali, oil and organic solvents, inflammable and explosive materials; The tube body should not be in direct contact with goods with sharp edges.

For the hose that needs to be transported straight, when the length exceeds the loading vehicle phase, the extra long part should be supported by a bracket to prevent the hose from being damaged by dragging on the ground.

If the hose needs to be temporarily parked in the open air (or workshop dock) for some reason, the site must be smooth, the hose should be placed neatly and flat, and the bottom mat should be covered, and no weight should be piled; At the same time, the hose should not be in contact with heat sources.

When handling hoses, should not drag anywhere, heavy hoses should use lifting equipment or special tools to load and unload, and to prevent accidental damage to the hose.

Hose storage

(1)The warehouse where the hose is stored should be kept clean and ventilated, the relative temperature should be below 80%, the temperature in the warehouse should be kept between 15 and +40C, and the hose should be avoided from direct sunlight and rain and snow.

(2) When the hose is stored, it should be placed separately according to different varieties and specifications, not mixed up, and marked for access.

(3) The hose is stored in a relaxed state as far as possible, generally for the hose with an inner diameter below /6mm, it can be stored in a reel (but the inner diameter of the disc should not be less than 15 times the inner diameter of the hose).

(4) In order to prevent the tube body pressure deformation when the hose is stored, the stacking should not be too high, and the general stacking height should not exceed 1.5m; And the hose is required to "reverse stack" often during storage, generally no less than every quarter once.

(5) When the hose is stored, it should not be in contact with acids, alkalis, oils, organic solvents or other corrosive liquids and gases; And should be away from the heat source 1m

(6) During the storage period of the hose, heavy objects are strictly prohibited on the pipe body to prevent external extrusion and damage.

(7) The storage period of the hose should generally not exceed two years, and it should be used first to prevent the quality of the hose from being affected by too long storage.